Click to visit GAUGEMASTER's home page.
Click to visit RIGHT LINES home page.

Point Motors Part 3: Other Uses for Point Motors

Image of MATT LOVELL.MATT LOVELL shows us what point motors can do beyond just points.


In previous articles we have looked at different styles of point motors including Solenoid Basics and Slow-Action designs from various manufacturers. Now, we all know the primary function for a point motor is to throw the tie-bar on a point and operate the blades in the desired direction - However point motors can also be used for other features and functions. In this article we will look at how point motors can be used in different ways.

Electrical Operation

Most point motors come with an auxiliary switch, this means that when the point motor operates it acts as a single pole double throw switch. I have listed below a few examples of how this switch can be used.

Switching LEDs: By wiring the common on the point motor switch to a power supply, you can use the switch to power a set of LEDs on a control panel or mimic board.

Point Motors Uses 01.

Click image to view larger version.

This is useful as you do not need to wire up a separate relay or other switch to show the direction of the point.

Colour Light Signals: Using the same method as above, you can use the point motor to operate either a single or double head twin aspect signal.

Point Motors Uses 02.

Click image to view larger version.

This method can be used in platforms, sidings and other railway scenes.

Layout Section switching: By using the switch built into the point motor you can switch sections of a layout on and off. This could be used in sidings, interlock sections and for adding switchable isolating sections to a mainline system.

Point Motors Uses 03.

Click image to view larger version.

Create an isolating section by cutting the track on one rail, and then make another cut on the same section leaving a gap about the length of your longest locomotive. This is ideal for signalled sections.

Go Back To Top

Mechanical Switching:

Other than electrical ways, point motors can be used to mechanically operate items on the railway.

Semaphore Signals: Many years ago, Hornby developed a small range of semaphore signals which were attached to a large plastic base, a solenoid motor could then be placed on the base and with a small section or wire the signal could be actuated in the required direction.

Point Motors Uses 04.

Click image to view larger version.

The newer designs of these signals do not have this large plastic base so slight modification will be required. The easiest modification I have found is to drill a hole in line with actuating bar on the signal and attach a piece of wire between the two. This will enable you to throw the signal using the motor.

Slow action gates or doors in factories: Using the slow action motors, the actuating arm can be attached to a factory gate, and when the point motor is in operation the gate moves up and down. For opening doors, attach the actuating bar to a set of doors so that the bar moves away.

These are just some other ways of using point motors, Contact Us if you can think of any others!

Other Parts in this Series on Point Motors:

Go Back To Top